Filter
Top Products
Section 7
41
12. Clean and remove the check plug dipstick from the
center gearbox and fill the gearbox with Mobil
SHC630 lubricant until it is full, as indicated on the
dipstick. Install the check plug dipstick and tighten
securely, then back the dipstick out so that the slot is
parallel with the front of the gearbox.
13. Clean and remove the check plug from the left
gearbox. Fill the gearbox with Mobil SHC630
lubricant through the check plug hole until it starts to
exit the hole. Install the check plug and tighten
securely.
14. Repeat step 13 on the right gearbox.
15. Clean the three breathers with a non-flammable
solvent.
16. Install the foot plate to the cutter deck.
Do not wash any portion of the equipment
while it is hot. Do not wash the engine; use
compressed air.
CAUTION:
1. After each use, wash the mower, deck and hopper.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
2. Do not spray electrical components.
3. Use a mild soap solution or a vinyl/rubber cleaner to
clean the seat.
4. Repair damaged metal surfaces and use Scag touch-
up paint available from your authorized Scag dealer.
Wax or polish the mower for maximum paint
protection.
7.14 BODY, DECK, HOPPER AND
UPHOLSTERY