Filter
Top Products
13
2-18 Throttle Cable Installation
To install the throttle cable kit to the box assembly, align
the large end of the slot in the throttle base plate (Figure
2-18a) with the rivets located on the front of the box
assembly frame (Figure 2-18b). Place the throttle base
plate over the rivets, Slide the throttle cable kit to the right,
moving the smaller end of the slot over the rivets. When
positioned correctly, the throttle spring plate will snap into
place (Figure 2-18c).
To remove the throttle cable kit, lift the throttle spring plate
and slide the throttle kit to the left.
Route cable under upper hose as shown in Figure 2-18d.
To fasten the throttle cable end to the engine, place the
throttle control lever into the “stop” position. Rotate the
engine throttle lever to the “stop” position. Thread the
wire end of the throttle cable into the engine throttle lever
eyelet and tighten the screw. Fasten the throttle cable
sleeve to the clamp on the engine throttle (Figure 2-18e).
Rotate the throttle control lever into the “fast” position to
check for proper installation.
Cable sleeve may need to be cut, depending on
the engine type. Once throttle cable is attached, pull the
box handle to dump the box and be sure the cable does
not alter the movement of the box.
NOTE:
Figure 2-18d.
Figure 2-18e.
Cable Clamp
Engine Throttle Lever
Figure 2 -18a.
Throttle Cable
Throttle Base Plate
Throttle Spring
Plate
Throttle
Figure2-18b.
Figure 2-18c.
Throttle Cable Kit
Properly Positioned
Box Assembly
Rivet
Box Assembly