Filter
Top Products
12 13
OPERATION
Fig. 10
Fig. 12
Fig. 11
PRIMER
BULB
n Slowly push the primer bulb seven times.
NOTE: If restarting a warm engine, do not push the primer
bulb.
n Set the start lever to the START position.
NOTE: If restarting a warm engine, leave the choke in
the RUN position.
n Pull the starter cord until the engine runs.
n Return the starter cord gently to the starter housing. Do
not allow the rope to snap back.
n Allow the engine to run for 15 seconds to warm up before
using.
n Engage the throttle lever to operate.
To stop the cultivator:
n Release the throttle lever.
n Move the engine switch to the OFF ( O ) position.
PREPARING THE SEED BED
See Figure 13.
The cultivator can be used to break up garden soil and prepare
a seedbed for planting. Plan ahead to leave enough room
between the seed rows to allow for machine cultivating after
the plants have grown.
n With the wheel assembly accessory installed in position
A as described on page 14, roll the machine to the work
area.
n For general cultivating, remove or adjust the wheel assem-
bly accessory using the guidelines in “Adjusting Wheel
Position” on page 14.
n The drag bar has two installation positions to choose
from. Based on the type of soil being cultivated and
soil conditions at the time, the appropriate height of the
drag bar will vary. Adjust the drag bar position using the
guidelines in “Adjusting Drag Bar Position” on page 14.
n Start the engine.
n Stand behind the unit with the tines on the ground and
the work area clean and free of obstructions.
n Completely engage the throttle lever to begin tine
rotation.
NOTE: If the machine moves forward too quickly and
wheels are in position A or B with drag bar installed, push
down on the handlebar to allow the drag bar to penetrate
the soil and slow the forward motion of the unit. The rotat-
ing tines help to pull the machine forward, so use slower
speeds and a shallow depth setting when learning to use
the unit and when cultivating on hard, rough, or uneven
ground.
n Always operate the unit at full throttle when cultivating.
RECOIL
STARTER
NOTE: Several passes over the same path may be required
to reach the desired depth. Do not try to dig too deeply in
the first pass. If the machine jumps or bucks, allow the unit
to move forward at a slightly faster rate or install wheel as-
sembly accessory.
To dig more deeply, lift up on the handlebar. Apply downward
START
LEVER
START
POSITION
RUN
POSITION
START
LEVER