Filter
Top Products
10
Motor 18 Volt, DC
Bar Length 10 in. (254 mm)
Replacement Bar Part No. 671256002 or 671667002
Replacement Chain Part No. 6958301 or 690583002
Net Weight 7.5 lbs. (3.4 kg.)
Charger Replacement Part Number 1423701
Battery Pack Replacement 1322401, 1323303,
Part Number 130224007,
or 130256001
Charger Rating 120V, 60 Hz, AC Only
Charger Voltage 18 Volt
Charger Rate 1 Hour
PRODUCT SPECIFICATIONS:
This chain saw has been shipped completely assembled and ready for use. After removing it from the box, inspect
it carefully to make sure no breakage or damage has occurred during shipping. If any parts are damaged or missing,
contact your nearest Ryobi Authorized Service dealer to obtain replacement parts before attempting to operate the
chain saw. The guide bar, chain, wrench, bar and chain oil, scabbard, battery pack, battery charger, and this operator’s
manual are also included.
KNOW YOUR CHAIN SAW
See Figure 1.
Before attempting to use the chain saw, familiarize
yourself with all operating features and safety require-
ments.
WARNING:
Carefully read through this entire operator’s
manual before using your chain saw. Pay close
attention to the Important Safety Instructions,
Warnings and Cautions. If you use your chain
saw properly and only for what it is intended, you
will enjoy years of safe, reliable service.
WARNING:
Do not allow familiarity with your chain saw to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict severe
injury.
WARNING:
If any parts are missing, do not operate your
chain saw until the missing parts are replaced.
Failure to do so could result in possible serious
personal injury.
The chain saw can be used for the following applications only:
■ Limbing and pruning branches from trees.
■ Felling small trees up to 5 in. (127 mm) diameter.
■ Bucking the fallen tree into shorter lengths.
NOTE: This saw was designed for occasional light duty use and has some limitations as to what can
be cut with it.
SPECIFICATIONS
UNPACKING
APPLICATIONS
FEATURES