Ryobi RY30570 Brush Cutter User Manual


 
12
ATTACHING THE FRONT HANDLE - CS30 AND
SS30
See Figure 4.
Remove wing nut, washer, and bolt from the front
handle.
Install the front handle onto the top side of the drive shaft
housing in the area indicated by the label.
NOTE: The open side of the handle should face the
operator.
Place the bolt through the front handle.
NOTE: The hex bolt head fits inside the hex recess molded
into one side of the handle.
Reinstall the washer and wing nut.
Tighten wing nut securely.
ATTACHING THE “J” HANDLE - BC30
See Figure 5.
A “J” handle must be used for ensuring the best control and
maximizing operator safety when using a brushcutter.
Hold the top and bottom clamp snugly in position on
the shaft housing so that handle will be located to the
operator’s left.
Insert the end of the handle between the clamps.
Align the bolt holes and push the long bolt (1/4-20 x
1-1/2 in.) through the handle side.
Place short bolt (1/4-20 x 1 in.) through opposite side of
clamp. Install flat washers, lock washers, and hex nuts
to hold the assembly in place.
After assembly is complete, adjust the position of the
handle to the area indicated by the label on the drive
shaft housing.
Tighten first the long bolt and then the short bolt.
ASSEMBLY
WING
NUT
FRONT HANDLE
BOLT
Fig. 4
Fig. 5
CLAMP
FLAT WASHER
LOCK WASHER
HEX NUT
STRAP
HANGER
BOLT
1/4-20 x 1-1/2 in.
CLAMP
FRONT
HANDLE
BOLT
1/4-20 x 1 in.
WASHER