Ryobi RY08576 Blower User Manual


 
12
WARNING
Keep away from all hot surfaces of the blower. Failure to
do so could result in possible serious personal injury.
OPERATING THE BLOWER
See Figure 8.
Start the blower. Refer to Starting and Stopping earlier
in this manual. Slip arm through harness strap and onto
shoulder, then repeat for the other shoulder. Adjust the
straps to a comfortable position. Refer to Adjusting Har-
ness and Waist Straps earlier in this manual. Operate
the blower from the right side as shown in illustration.
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Operate blower at the lowest possible throttle speed to
do the job.
Check your equipment before operation, especially the
muffler, air intakes, and air filters.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
Watch out for children, pets, open windows or freshly
washed cars, and blow debris safely away.
Use the nozzle for larger volume, so the air stream can
work close to the ground.
After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
CRUISE CONTROL/THROTTLE LOCK
See Figure 9.
The cruise control (throttle lock) can be used to operate the
blower without holding the throttle trigger.
To engage the cruise control/throttle lock:
Pull cruise control lever back toward user, and stop at
the desired throttle setting.
To release the cruise control, push cruise control lever all
the way toward the front of unit.
Fig. 8
OPERATION
Fig. 9
CRUISE CONTROL
(THROTTLE LOCK)
THROTTLE TRIGGER
PROPER OPERATING POSITION