Filter
Top Products
10
ASSEMBLY
INSTALLING TRIGGER HANDLE HOLDERS
See Figures 4 - 5.
Place top trigger handle holder over handle bar and align
holes.
Secure using screws and nuts as shown.
While holding screw with Phillips screwdriver, tighten each
nut with wrench to secure.
Repeat process to install bottom trigger handle holder.
Clip flat area of trigger handle into top holder and bottom
ribbed area of trigger handle into bottom holder. Slide
forward until trigger handle rests securely in holders.
Rotate trigger handle so that bottom edge of handle snaps
into handle lock.
ASSEMBLING THE SPRAY WAND
See Figure 6.
Insert the end of the spray wand into the trigger handle
outlet coupler as shown in figure 6 and push together
until coupler snaps into place.
Fig. 5
Fig. 4
HANDLE
LOCK
TOP TRIGGER
HANDLE HOLDER
BOTTOM TRIGGER
HANDLE HOLDER
Fig. 6
SPRAY
WAND
OUTLET
COUPLER
TRIGGER
HANDLE
RELEASE