Filter
Top Products
ASSEMBLY INSTRUCTIONS
RULES FOR SAFE OPERATION
6
INSTALLING FRONT HANDLE
After removing your hedge trimmer from its carton,
remove the front handle, screw, and lock nut from the
plastic bag. Using a flat blade screwdriver, which is the
only tool needed for assembly, install as follows:
WARNING: To prevent serious personal
injury, the handle must be installed when
operating this unit.
1. Turn the front handle so that the flat surface faces
the blade guard of your trimmer.
Fig. 1
APPLICATION
This unit is intended for household purpose only.
Use the Hedge Trimmer for;
• Trimming and the forming of hedges, shrubs, and
bushes with a branch diameter of up to 3/8 inch.
Fig. 2
KNOW YOUR UNIT
Screw
Screw
Lock Nut
Handle Slot
Blade Guard
Front Handle
Rear Handle
Ears
Rear Handle
Lock Nut
Front Handle
Blade Guard
Cutting Blade
NOTE: The hollow side of the front handle faces the
rear handle when installed properly.
2. Spread the ears of the front handle and fit into the
handle slots on the motor housing (Fig. 1).
NOTE: For your convenience and ease of assembly one
of the ears on the front handle has been keyed.
3. Place your trimmer on a workbench and place lock
nut into molded slot on right side of the front handle.
4. Insert screw from left to right through the front
handle and motor housing (Fig. 2).
5. Tighten screw and lock nut securely with a flat blade
screwdriver.
Extension Cord
Retainer
Switch Trigger
Lock-On Tab
Lock-Off Button