Filter
Top Products
MAINTENANCE AND REPAIR INSTRUCTIONS
11
8. Replace blade screws. Tighten screws securely.
9. Replace blade cover screw (Fig. 14).
NOTE: Do not tighten blade cover screw until blade
cover has been replaced.
10. Replace blade cover. Place rear tab inside housing,
align front tabs with slots in housing, then slide blade
cover back into its correct position (Fig. 15).
11. Tighten blade cover screw securely.
WARNING: Make sure blade cover is
replaced before connecting your hedge
trimmer to power supply. Failure to do so will
expose internal parts which could cause an
accident or electrical shock resulting in
serious injury.
NOTE: If binding occurs after replacing blade assembly,
repeat the steps above for reassembly.
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Blade Cover
Screw