Filter
Top Products
MAINTENANCE AND REPAIR INSTRUCTIONS
20
CARBURETOR ADJUSTMENT
The factory carefully calibrated the carburetor.
It seldom needs further adjustment.
Careless adjustments can seriously damage
your unit. An authorized service dealer must
make carburetor adjustments.
Check Fuel Mixture
Old and/or improperly mixed fuel is usually the
reason for the unit not running properly. Drain
and refill the tank with fresh, properly mixed fuel
prior to making any adjustments. Refer to
Oil and Fuel Information Pg. 11.
Clean Air Filter
The condition of the air filter is important to the
operation of the unit. A dirty air filter will restrict
air flow and change the air/fuel mixture. This is
often mistaken for an out of adjustment
carburetor. Check the condition of the air filter
before adjusting the idle speed screw. Refer to
Air Filter Maintenance Pg. 18.
Adjust Idle Speed Screw
WARNING: The cutting attachment
may be spinning during carburetor
adjustments. Wear protective
clothing and observe all safety
instructions to prevent serious
personal injury.
If after checking the fuel mixture and cleaning
the air filter the engine still doesn’t idle, adjust
the idle speed screw as follows.
1. Start the engine and let it run at a high idle
for a minute to warm up.
2. Release the throttle trigger and let the engine
idle. If the engine stops, insert a small
phillips or flat blade screwdriver into the hole
in the air filter/muffler cover (Fig. 35). Turn the
idle speed screw in, clockwise, 1/8 of a turn
at a time (as needed) until the engine idles
smoothly.
NOTE: The SpeedSpool® cutting attachment
should not rotate when the engine
idles.
3. If the SpeedSpool® cutting attachment
rotates when the engine idles, turn the idle
speed screw counterclockwise 1/8 of a turn
at a time (as needed), to reduce idle speed.
Checking the fuel mixture, cleaning the air filter,
and adjusting the idle speed screw should solve
most engine problems.
If not and:
• The engine will not idle,
• The engine hesitates or stalls on
acceleration,
• There is a loss of engine power,
Have the carburetor adjusted by an authorized
service dealer.
WARNING: When the unit is turned
off make sure the cutting attachment
has stopped before the unit is set
down to prevent serious personal
injury.
Fig. 35
Idle Speed Screw