Ryobi 725r Trimmer User Manual


 
INSTALLING THE CUTTING
ATTACHMENT SHIELD
Use the following instructions if the cutting
attachment shield on your unit is not installed.
WARNING: Never operate the
trimmer without the cutting
attachment shield in place to prevent
serious personal injury.
1. Place the cutting attachment shield onto the
shaft housing above the clamp assembly, so
that the
shield
is in front of the cutting
attachment (Fig. 7).
5. Tighten the clamp screws evenly until the
J-handle is secure.
ASSEMBLY INSTRUCTIONS
10
2. Push the cutting attachment shield down to
the top of the cutting attachment assembly.
Rotate the cutting attachment shield so that
it points to the engine, and the holes in the
cutting attachment shield line up with the
holes in the top of the cutting attachment
assembly (Fig. 8).
3. Install the four (4) screws with a small Phillips
screwdriver (Fig. 8).
Cutting Attachment Shield
Screw
Shaft Housing
Cutting Attachment
4. While holding the unit in the operating
position (Fig. 6), position the J-handle to the
location that provides you the best grip.
Fig. 6
Fig. 7
Fig. 8
Decal
Fig. 5
Model 725r
3. Slide the J-handle out until the arrow/white
line on the decal touches the clamp
assembly (Fig. 5).