Filter
Top Products
MAINTENANCE AND REPAIR INSTRUCTIONS
16
9. Place the spring in the inner reel. Insert the
ends of the line through the eyelets in the
outer spool and place inner reel inside the
outer spool (Fig. 19). Push the inner reel and
outer spool toghther. While holding the inner
reel and outer spool, grasp the ends and pull
firmly to release the line from the holding
slots in the spool.
NOTE: The spring must be assembled on
the inner reel before reassembling
the cutting attachment.
7. Wind the lines in tight even layers, onto the
reel (Fig. 17). Wind the line in the direction
indicated on the inner reel. Place your index
finger between the two lines to stop the lines
from overlapping. Do not overlap the ends
of the line.
NOTE: Failure to wind the line in the direction
indicated will cause the cutting
attachment to operate incorrectly.
8. Insert the ends of the line into the two
holding slots (Fig. 18).
Fig. 17
Fig. 18
Fig. 19
Fig. 16
6. Take approximately 25 feet (7.6 m) of new
0.080 in. (2.03 mm.) trimming line, loop it into
two equal lengths. Insert each end of the line
through one of the two holes in the inner reel
(Fig. 16). Pull the line through the inner reel
so that the loop is as small as possible.
NOTE: Always use the correct line length
when installing trimming line on the
unit. The line may not release properly
if the line is too long.
10.Hold the inner reel in place and install the
Bump Knob™ by turning clockwise. Tighten
securely.