Filter
Top Products
17 18
19
20
Set the Left Door Panel (AK) face down on the ground.
Slide the Hinge Reinforcement (PP) into the hole on the top door pin. The Hinge
Reinforcement (PP) will slide in until it is below the end of the door pin.
AK
PP
AK
AK
PP
Starting at the top of the door, slide the Door Reinforcement (NN) onto the groove located
on the handle side of the door. The Door Reinforcement (NN) will slide to the stop at the
bottom of the door.
Install the Gasket (MM) into the gasket groove in the door. Start at the top and middle, by
pushing the gasket into the groove. Continue until the Gasket (MM) is fully installed.
There will be a small gap between the ends of the gasket.
NN
NN
AK
AK
NN
AK
MM
MM
AK
Start
Install the Window (LL) onto the door by matching up the holes and installing the Screws
(KK) and Washers (TT) 15 places. The “frosted” side of the window should be touching
the gasket. Install screws in order starting at position 1.
Repeat steps 20-23 for Right Door Panel (AF).
Caution: Tighten screws only enough to compress gasket.
Do not overtighten.
KK
(15)
TT
(15)
AK
KK
TT
LL
15
10
11
12
13
14
1
2
3
4
5
6
7
8
9