Filter
Top Products
21
6
LUBRICATION – Pre-lubricate, sealed ball races are fitted to the cutter, drum shaft, countershaft
and front roller. No further lubrication is necessary to these 8 races.
Drums are fitted with special self-lubricating bushes and do not require lubrication.
Driving Chains – grease or medium oil used sparingly.
Gear Box – use medium oil at points B, C and D. Use grease sparingly on gear teeth.
FRONT ROLLER SCRAPER – Loosen clamp bolt each end, adjust scraper to just clear the roller
and re-tighten clamps.
CLEANING – This mower is constructed of first-class materials, and will give longer and more
efficient service if kept clean. After cutting and before putting machine away, wipe blades down with
an oily rag. Occasionally check nuts and bolts for tightness.
WARNING – State Electricity Authority regulations provide that it is always necessary to disconnect
power supply before effecting any adjustments to the machine.
ELECTRIC MOTOR
MODEL 300361 1.5 HP 240V SINGLE PHASE 7.3 AMPS.
MODEL 300433 1.5 HP 415V THREE PHASE 2.6 AMPS.
NOTE: Model No: 300361 Queen
TM
mower is fitted with a manual reset overload switch.
The reset button is located on the mains power switch mounted on the right hand side of the
handles.
FITTING INSTRUCTIONS 30” TEASING RAKE
1. Remove front roller
quadrant bolts and nuts
(A and B), and also roller
adjusting rod nut (C) at both
sides of the mower.
2. This allows front roller
assembly, complete with
bottom spacer tube to be
removed clear of machine.
3. Remove spacer tube from
roller assembly by tapping
off quadrant from the roller
ball race.
5. The quadrant bolt “A”,
must enter the square hole
in the rake supporting plate
“B”, before re-assembly to
the mower.
6. Re-adjust front roller to
desired height of cut (as
described in the mower
instruction manual).
7. Adjust teasing rake depth
so that it is just able to tease
up the runners. Adjustment
is effected by loosening bolt
4. Replace bottom spacer
tube with teasing rake
assembly with rake sections
facing frontwards.
“A” each side and adjusting the rake height as required. To
raise, unscrew nut “B” and take up with slack “C”. Retighten
“A”. Reverse procedure to lower rake.
3676 Queen 30 Reel Mower.indd 7 22/11/2005 4:27:38 PM