Filter
Top Products
25
2
MAINTENANCE AND ADJUSTMENT
30” QUEEN
TM
ELECTRIC MOWER 2 SPEED OPERATION
Normal Speed _ 4.9km/p.h 127 cuts per metre.
Low Speed _ 3.2km/p.h 183 cuts per metre.
SPEED CONTROL
To change speed, stop motor and move ribbed sliding
sleeve (A) inwards to engage normal speed or outwards
for low speed as required. It may be necessary to twist the
sleeve or countershaft backwards and forwards slightly
whilst sliding the sleeve position to allow the gear teeth to
line up and mesh fully.
FRONT ROLLER – The height of the cut of the Mower is controlled by the adjustment of the front
roller. The machine cuts lower if the front roller is raised, or alternatively, the machine cuts higher
if the front roller is lowered.
WARNING
Model 300433 415 volt 3 phase Queen
TM
mower
Before use the rotation of the electric motor mounted on the Queen
TM
mower has to
be checked for the correct direction of rotation with the local power supply to be used.
This is at the onus of the purchaser and must be completed by a qualified electrician.
Use extreme caution when performing the following inspection due to exposed
rotating parts.
1. With the power supply disconnected remove the motor cover and disengage all clutches.
2. Connect the power supply to the mower.
3. Switch the power on.
4. Move to the right hand side of the mower and note the direction of rotation of the motor
pulley when looking directly at the end of the motor shaft. It should be rotating in the
clockwise direction (left to right). Switch the motor off and disconnect the power supply.
5. If the direction of rotation of the motor is correct replace the motor cover and proceed
to use the mower. If the direction of rotation of the mower shaft is incorrect contact a
qualified electrician to have the motor rotation reversed to suit your power supply.
3676 Queen 30 Reel Mower.indd 3 22/11/2005 4:27:31 PM