Filter
Top Products
OPERATING INSTRUCTIONS
TO START THE ENGINE:
Note the engine will not start unless the cutter drive is
disengaged, and clutch/brake pedal is depressed.
-
Depress clutch/brake pedal – Apply the park brake;
-
Move the speed selector to neutral;
-
Disengage the cutter drive;
-
Move the throttle lever to the choke position;
-
Turn the ignition key to the start position and release;
-
when the engine starts;
-
Move the throttle lever to about ¼ position.
TO MOW OR DRIVE:
-
Depress clutch/brake pedal;
-
Disengage the parking brake;
-
Select height of cut;
-
Move throttle to about ¾ position;
-
Engage cutter drive;
-
Select desired speed;
-
Slowly release clutch/brake pedal to move off.
TO STOP ENGINE:
-
Depress clutch/brake pedal;
-
Move the speed selector to neutral;
-
Disengage the cutter;
-
Apply the parking brake;
-
Move the throttle lever to the slow position;
-
Turn the ignition key to Off. Remove the keys;
IMPORTANT:
- The parking brake should always be applied before
leaving the machine;
- The parking brake must be released before attempting to
drive;
- Depress the clutch/brake pedal when selecting or
changing speed;
- Do not select speed while the machine is moving.
ENGAGING CLUTCHES:
- When engaging the cutter drive lever or releasing the
clutch/brake pedal, always operate slowly. Do not use a
jerking motion. Moving these controls too fast could
possibly overload and stall the engine.
CAUTION:
- To avoid loss of control always come to a complete
stop before selecting speeds and slow down when
turning.
REMEMBER:
- Always look behind the machine before reversing;
- Do not refuel when the engine is running or while it is
hot;
- Keep bystanders away – Keep hands and feet clear of
moving parts;
- Keep the machine clear of grass and debris;
- Keep all guards in place;
MAINTENANCE INSTRUCTIONS
Periodically check the machine and cutting mechanism. If
parts are worn or need replacing do so by using only Genuine
Rover Replacement Parts.
There is a comprehensive Rancher Spare Parts List contained
in this book to help you select the right part quickly.
Before working o the mower, disconnect the spark plug lead
from the spark plug and place it where it cannot contact the
spark plug.
CHECK YOUR Rover rancher frequently for loose nuts,
bolts, belts, etc., and keep these items correctly tightened and
adjusted.
Note: A check after the first two hours operation is
recommended. Engine failure or rapid engine wear mainly
result from the following causes –
1. Dirt or abrasives entering the engine via the air
cleaner due to –
a).
The air cleaner element not being serviced
regularly;
b).
The air cleaner damaged or dislodged.
2. Dirt or abrasives entering the engine via the oil filler
tube due to –
a).
Using a funnel not cleaned of dirt and grit,
b).
Topping up with contaminated oil. Oil stored in
an unclean container.
3. Lack of oil. It is important to –
a).
Check the oil level regularly ( every 5 hours of
operation),
b).
Maintain a full sump.
6