Filter
Top Products
3)
3)
Tighten the cover bolt.
NOTE: The bolt cannot be tightened unless the front cover and rear cover are positioned correctly.
The shape of the cover bolt is shown below.
Install the rear cover to fit the rotor bearing.
Lightly strike the circumference of the rear cover
evenly with a plastic hammer. (See Fig. lo- 22.)
NOTE: Be careful not to pinch the wires between
the stator and rear cover.
Fig. lo-22
r=
I
,
Model
d
1 1 s
I
RGX180 i
6mm j
90mm ’ 15mm
0.24in. 1 3.54 in.
0.54 in.
RGX240
6.3 mm
100 mm 15mm
RGX240D
0.24 in.
3.94 in. 0.54 in.
Table 10-2
Install the stator cover.
Fit the stator cover between the stator and cover bolts
until it covers all the cover bolts. and fold back -:he
edge.
Pass the wires out of the top of rear cover through the
grommet. and fit the grommet into the hole in the rear
cover. (See Fig. 10-X .i Then. reverse the bushing for
mountmg the control box and place it on the grommet.
The bushing has a larger diameter than the grommet.
Fig. lo-23
- 49 -