Filter
Top Products
ASSEMBLY
TURBO 96 01/11 Assembly Section 3-10
© 2011 Alamo Group Inc.
ASSEMBLY
DRIVELINE ATTACHMENT
Before starting assembly, make certain that all
paint, dirt, and grease are removed from gearbox
shaft (1). To ease assembly apply a light coat of
grease to splines and assemble. Do not assemble a
driveline without a shield. (Figure Asm-R-0129)
Attach the slip clutch end of the driveline to the
gearbox input shaft securely. Make certain that the
slip clutch is fully onto the input shaft splines.
Tighten the locknuts (2) alternately until they have
reached the proper torque. Refer to Torque Chart in
Maintenance Section.)
SHIELD ASSEMBLY - Side Drives - Lift and Pull
Attach the Brackets (1& 2) to the Gearbox. Install
Shield (3) to brackets (1 & 2) with Bolt (4)
Flatwashers (5) and locknut (8). Close Shield and
retain with Bolt (6), Flatwasher (5) and with Thumb
nut (7). (Figure Asm-R-0297) Proceed to attach
Divider Shield (1) with bolt (2) and Lockwasher (3).
Retain Divider Shield with Thumb Nut (4) and
Flatwasher (5). (Figure Asm-R-0298
SHIELD ASSEMBLY - Main Input - Lift and Pull
Attach the Bracket (1) to the Center Gearbox with
M10 x 35 Bolts (2), and Flatwasher (3). Install
Shield (5) and retain with 1/2” Wing Nut (4).