Filter
Top Products
ASSEMBLY
TURBO 96 01/11 Assembly Section 3-6
© 2011 Alamo Group Inc.
ASSEMBLY
AXLE ASSEMBLY - HYDRAULIC OFFSET & SEMI-MOUNT
Attach rear axle (1) to lugs on rear of mainframe using bolts (2), and locknuts (8). Clamp caster wheel
assembly (2) to axle arm plate (3), using bolt (4), and locknut (9).
CONTROL RODS - PULL TYPE
Attach the two level-lift control rods to the lower lugs on tongue and to lugs on the rear axle tube using pins,
washers and cotter pins.
NOTE: The adjusting nuts on control rods should be to rear of machine and should always be adjusted with
equal tension on both rods. Figure Asm-R-0289 & Asm-R-0290.