Filter
Top Products
Maintenance Section 5-3
MAINTENANCE
GK6072 08/01
© 2004 Alamo Group Inc.
MAINTENANCE
GEARBOX
The Gearbox has been filled with lubricant to the Test Plug Level prior to shipment. However, you should check
the oil level at Test Plug before operating, and frequently thereafter.
The gearbox should not require additional lubricant unless the box is cracked or a seal is leaking. It is recommended
that the oil level plug be removed after every 8 to 10 hours of operation and oil added until it runs out Test Plug hole.
The Test Plug is located on the side of the Gearbox. Filler Plug is located on top of Gearbox. Figure 2.
FIGURE 2
Recommended lubricant is NLGI Grade 000 Grease (P/N 00765444) with the capacity of one quart.
NOTE: Overfilling the Gearbox will cause pressure to build up and cause Oil Seals to leak.
ATTENTION: If the Gearbox suddenly starts making an unusual noise, stop at once, check for leaks, and refill
Gearbox as required.
GAUGE WHEEL ASSEMBLIES
Gauge wheels are equipped with bushings which require grease daily. Grease Fittings are provided in the Wheel
Hub and Gauge Wheel Pivot . Grease after 8 hours of use. FIGURE 3 &4.
FIGURE 3 FIGURE 4