Filter
Top Products
Operation Section 4-5
OPERATION
GK6072 08/01
© 2004 Alamo Group Inc.
OPERATION
Driveline in maximum compressed positionDriveline in maximum compressed position
Driveline in maximum compressed positionDriveline in maximum compressed position
Driveline in maximum compressed position
1/8 INCH
COLORED TAPE
FIGURE 2FIGURE 2
FIGURE 2FIGURE 2
FIGURE 2
BEFORE OPERATING OR TRANSPORTING THIS MOWER
Always display this SMV emblem (FIGURE 1) on the rear of the tractor transporting this mower where it is clearly
visible to oncoming traffic. Prominent display of this symbol will help the operator avoid accidents which could
cause injury or possibly death.
FIGURE 1
DRIVELINE LENGTH CHECK PROCEDURE
WARNING! A loose shaft could slip off and result in personal injury or dfamage to cutter. When attaching
PTO yoke to tractor PTO shaft, it is important that spring activated locking collar slides freely
and locking balls are seated in groove on PTO shaft.
WARNING! Before operating cutter, check to make sure the driveline will not bottom out or become
disengage.
* Disengage the Driveline from the tractor PTO Shaft.
* Slide the Driveline together until it "bottoms out" solidly.
* Apply colored tape to the Inner Shield 1/8" from the end of the Outer Shield. FIGURE 2
* Re-attach the Driveline to the PTO Shaft.