Filter
Top Products
MAINTENANCE
FN180/FN120 01/11 Maintenance Section 5-5
©2011 Alamo Group
MAINTENANCE
CENTER & WING GEARBOXES
.
The Gearboxes have been filled with lubricant to
the proper Level prior to shipment. However, you
should check the oil level on dipstick before
operating, and frequently thereafter.
The gearbox should not require additional lubricant
unless the box is cracked or a seal is leaking. It is
recommended that the oil level dipstick be removed
after every 8 to 10 hours of operation and oil added
until it is at proper level on dipstick. Filler Plugs are
located on top of all Gearboxes. Use Rhino Special
Gearbox Lube (P/N 00786250)) with a capacity is 6-
1/2 quarts. FIGURE MntP-0004
DIVIDER GEARBOX
The filler pressure relief Dipstick Plug is on top of
the Gearbox. Mnt-R-0005
Do not over-fill. If Gearboxes are filled above full mark on Dipstick, pressure under working
conditions may cause the Grease Seals to leak.
Use Rhino Special Gearbox Lube (P/N 00786250). Gearbox capacity is 3 quarts for divider gearbox.
Many of the equipment components are HEAVY (60 lbs. or greater) and Special Lifting
Procedures are recommended. Use lifting assistance such as mechanical assistance, two
people, or proper lifting techniques when handling, removing or installing components to
reduce the possibility of back injuries.