Filter
Top Products
OPERATION
FN180/FN120 01/11 Operation Section 4-9
© 2011 Alamo Group Inc.
OPERATION
5.1 Connecting the Mower Tongue to the Tractor
1. Ensure the tractor is equipped with the
correct PTO shaft and the drawbar is set at
the correct length.
2. Using the parking jack, position the tongue
clevis to the height of the tractor drawbar.
Adjust the mower tongue to be level and
parallel with the tractor drawbar using the
control rod connecting the mower tongue to
the deck.
3. Board the tractor and start the engine. Back
the tractor to the mower aligning the drawbar
hitch hole with the mower tongue clevis.
Turn off the tractor engine, place the tractor
in park, and set the parking brake before
dismounting.
Never run the Tractor engine in a closed building or without adequate ventilation. The
exhaust fumes can be hazardous to your health.
(SG-23)
Start tractor only when properly seated in the Tractor seat. Starting a
tractor in gear can result in injury or death. Read the Tractor operators
manual for proper starting instructions.
(SG-13)
5. CONNECTING THE MOWER TO THE TRACTOR
Use extreme caution when connecting the mower to the tractor. The mower should be securely resting at
ground level or setting on blocks. Keep hands and feet from under the mower deck and clear of pinch points
between the tractor hitch arms and mower pins. OPS-R-0001
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches.
(S3PT-15)