Filter
Top Products
Maintenance Section 5-3
MAINTENANCE
© 2004 Alamo Group Inc.
FM100 02/04
MAINTENANCE
TEST PLUG
FILLER PLUG
GEARBOX
The Gearboxes have been filled with lubricant to the Test Plug Level prior to shipment. However, you should check
the oil level at Test Plug before operating, and frequently thereafter.
The gearbox should not require additional lubricant unless the box is cracked or a seal is leaking. It is recommended
that the oil level plug be removed after every 8 to 10 hours of operation and oil added until it runs out Test Plug hole.
The Test Plug is located on the back of the Gearbox. Filler Plug is located on top back of Gearbox. Figure 2.
GAUGE WHEEL ASSEMBLIES
Gauge wheels are equipped with
bearings which require grease dai-
ly. Grease Fittings are provided in
the Wheel Hub and Gauge Wheel
Pivot . Grease after 8 hours of use.
FIGURE 3 & 4.
FIGURE 2
Recommended lubricant is NLGI 000 Grease, Rhino P/N 00769030.
NOTE: Overfilling the Gearbox will cause pressure to build up and cause Oil Seals to leak.
ATTENTION: If the Gearbox suddenly starts making an unusual noise, stop at once, check for leaks, and refill
Gearbox as required.
FIGURE 3