Filter
Top Products
Safety Section 1-8
FM100 02/04
© 2004 Alamo Group Inc.
SAFETY
WARNING!
Be particularly careful when transporting the Implement with the Tractor.
Turn curves or go up hills only at a low speed and using a gradual
steering angle. Rear mounted implements move the center of gravity to
the rear and remove weight from the front wheels. Make certain, by
adding front ballast, that at least 20% of the tractor’s weight is on the
front wheels to prevent rearing up, loss of steering control or Tractor tip-
over. Slow down on rough or uneven surfaces to prevent loss of
steering control which could result in property damage or possible injury.
Do not transport unless 3-Point lift lever is fully raised and in the latched
transport position. Dropping implement in transport can cause serious
damage to the tractor and/or Implement and possibly cause the operator
or others to be injured or killed. (S3PT-2)
SAFETY
DANGER!
Always disconnect the main PTO Driveline from the Tractor before
performing service on the Mower. Never work on the Mower with the
tractor PTO driveline connected and running. Blades or Drivelines could
turn without warning and cause immediate entanglement, injury or death.
(SRM-3)
WARNING!
Do not let the Blades turn when the Mower Deck is raised for any
reason, including clearance or for turning. Raising the Mower
deck exposes the Cutting Blades which creates a potentially
serious hazard and could cause serious injury or even death from
objects thrown from the Blades. (SRM-7)
DANGER!
Replace bent or broken blade with new blades. NEVER ATTEMPT TO
STRAIGHTEN OR WELD ON BLADES SINCE THIS WILL LIKELY
CRACK OR OTHERWISE DAMAGE THE BLADE WITH SUBSE-
QUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN
BLADES.
(SGM-10)
DANGER!
Rotary Mowers are capable under adverse condi-
tions of throwing objects for great distances
(100 yards or more) and causing serious injury or
death. Follow safety messages carefully
-Front and Rear Deflectors, or Chain Guards, or Bands are installed
and in good, workable condition;
-Mower sections or Wings are running close to and parallel to the
ground without exposed Blades;
-Passersby are outside the existing thrown-object zone;
-All areas have been thoroughly inspected and all foreign material
such as rocks, cans, glass, and general debris has been removed.
NOTE: Where there are grass and weeds high enough to hide debris
that could be struck by the blades, the area should be: inspected
and large debris removed, mowed at an intermediate height, in-
spected closely with any remaining debris being removed, and mowed
again at desired final height. (This will also reduce power requiredto
mow, reduce wear and tear on the Mower drivetrain, spread cut
material better, eliminate streaking, and make the final cut more
uniform.) (SRM-1)
STOP MOWING IF PASSERSBY ARE WITHIN 100 YARDS UNLESS: