Filter
Top Products
Safety Section 1-9FM100 02/04
© 2004 Alamo Group Inc.
SAFETY
WARNING!
The rotating parts of this machine continue to rotate even after the PTO
has been turned off. The operator should remain in his seat for 60
seconds after the brake has been set, the PTO disengaged, the tractor
turned off, and all evidence of rotation has ceased. (3PT-10)
“Wait a minute...Save a life!”
SAFETY
WARNING!
Never leave Tractor and Implemented unattended while the implement is
in the lifted position. Accidental operation of lifting lever or a hydraulic
failure may cause sudden drop of unit with injury or death by crushing.
To properly park the implement when disconnecting it from the tractor,
lower the stand and put the retaining pin securely in place, or put a secure
support under the A-Frame. Lower the implement carefully to the ground.
Do not put hands or feet under lifted components. (SPT-1)
DANGER!
Make sure the PTO shield, integral driveline shields, and input shields are
is installed when using PTO-driven equipment. Always replace any
shield if it is damaged or missing. (S3PT-8)
DANGER!
This Implement is wider than the Tractor. Be careful when operating
or transporting this equipment to prevent the Implement from running
into or striking sign posts, guard rails, concrete abutments or other
solid objects. Such an impact could cause the Implement and Tractor
to pivot violently resulting in loss of steering control, serious injury, or
even death. Never allow the Implement to contact obstacles. (S3PT-12)
DANGER!
There are obvious and hidden potential hazards in the operation of this
Mower. REMEMBER! This machine is often operated in weeds and
in heavy grass. The Blades of this Mower can throw objects if shields
are not properly installed and maintained. Serious injury or even death
may occur unless care is taken to insure the safety of the operator,
bystanders, or passersby in the area. Do not operate this machine
with anyone in the immediate area. Stop mowing if anyone is within
100 yards of mower. (SFM-1)
DANGER! All Safety Shields, Guards and Safety devices including
(but not limited to) - the Discharge Deflectors, Steel
Guards, Gearbox Shields, Belt Shileds, and PTO Shields
should be used and maintained in good working condi-
tion. All safety devices should be inspected carefully at
least daily for missing or broken components. Missing,
broken, or worn items must be replaced at once to
reduce the possibility of injury or death from thrown
objects, entanglement, or blade contact. (SFM-2)
WARNING!
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement. Place the Implement on the ground or securely
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work. (S3PT-9)