Filter
Top Products
OPERATION
1594 01/11 Operation Section 4-32
© 2011 Alamo Group Inc.
OPERATION
PEELING AND SCRAPING
Use a slight bucket angle, travel forward and
hold lift control forward to start the cut. Make a
short angle cut and break out cleanly.
With bucket level, start a cut at notch
approximately 2 inches deep. Hold depth by
feathering bucket control to adjust cutting lip up
or down. When front tires enter the notch, adjust
lift cylinder to maintain proper depth.
Make additional passes until desired depth is
reached. During each pass, use only bucket
control while working depth. This will allow you to
concentrate on controlling bucket angle to
maintain a precise cut.