Filter
Top Products
ASSEMBLY
1594 01/11 Assembly Section 3-7
© 2011 Alamo Group Inc.
ASSEMBLY
Connecting Quick Attach Device (Optional)
Attaching Quick Attach and Bucket to Loader
Refer to Figure Asm-L-0165.
1. Insure bucket is on firm and level ground. Remove pins (13) and retaining hardware (14, 15 & 16) from
quick attach.
2. Align boom pivot with bottom hole or quick attach secure with pin and retaining hardware.
3. Align 3-bar linkage bushing with bucket cylinder bushing and secure with pin and retaining hardware
When Connecting an Attachment to the Loader Quick Hitch
1. Be sure both quick hitch pin levers are in the unlocked position, with the levers pointing up. Tilt the loader
quick hitch forward, drive the loader into the attachment bracket and engage top of the quick hitch into the
top of the attachment bracket.
2. Raise the loader slightly and rotate the top of the quick hitch back toward the operator until the bottom of
the attachment is seated firmly in the bottom of the quick hitch.
3. Rotate the quick hitch pin levers down 90
degrees to the locked position. You should feel
a firm resistance when locking the levers down.
The tapered pins must extend through the slots
in the bottom of the attachment bracket. The
tapered side of the pins must be firmly wedged
against the surface of the slot at the bottom of
the attachment bracket. If the pins are not
wedged securely in place, the attachment may
fall off resulting in possible severe crushing
injury or death to the operator or bystander.
4. Raise the loader and attachment to shoulder
height. By standing at the side of the loader,
inspect the connection between the quick hitch
and attachment.
Never walk or work under or allow any person to be underneath a raised
loader or attachment.