Rheem GEN15ADC-E Portable Generator User Manual


 
37
Wireless Monitor Operation
1. Remove battery access cover (A) on back of monitor
and install 2 AA batteries. (Observe correct battery
polarity which is embossed in the bottom of the battery
compartment). Replace battery access cover.
NOTICE The wireless monitor was linked to the generator at
the factory. Communication will begin upon the installation
of the batteries and the generator being placed in AUTO
mode. You may need to press System Update one time
2. The wireless monitor does not have an on/off switch.
When batteries are installed correctly, the GENERATOR
READY green LED light will flash once every 7 seconds
indicating the status of the generator.
NOTICE If communication does not begin upon placing the
generator in AUTO, installing batteries, and pressing System
Update, the monitor may need to be re-linked. To link, follow
Steps 3 through 6.
3. Locate the MENU AND ESCAPE buttons on the control
panel (B). Press and hold for 3 seconds to enter the
linking mode.
 i-*/,*/(.0%&wXJMMTDSPMMBDSPTTUIFHFOFSBUPS
control panel.
5. Locate and hold the SYSTEM UPDATE button (C) on
the wireless monitor for 5 seconds. All 3 LEDs will
flash until the monitor links to the generator. Once it
links, the monitor will display the current state. The
monitor will try to link for 1 minute. (This step can only
be completed when the generator is in Linking Mode).
6. Once the link has been confirmed, press the OK
button on the generator control panel to exit or the
control board will turn off linking after 5 minutes. The
generator will now communicate with the wireless
monitor.
NOTICE It may take up to 1 minute for the monitor to begin
displaying the generator status correctly.
DEALER
NAME
DEALER
PHONE
generator power
service needed
system update
GENERATOR
POWER
SERVICE
NEEDED
SYSTEM
UPDATE
1 low battery voltage
2 low fluid level
3 under/over voltage
4 engine does not start
part #: 316197 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C
5 low frequency
6 engine overspeed
7 high temperature
8 transfer switch
# of flashes service needed
+
+
-
-
generator power
service needed
generator ready
system update
GENERATOR
POWER
SERVICE
NEEDED
GENERATOR
READY
SYSTEM
UPDATE
A
B
B
C