Filter
Top Products
IMPORTANT SAFETY INFORMATION
Saw Maintenance and Kickback
Safety
1. Unplug saw from power source:
• when not in use
• before moving from one place to an
other
• before servicing
• before changing accessories or attachments,
such as saw chain and guard
2.
Inspect saw before and after each use. Check
saw clos
ely if guard or other part has been dam-
aged. Check for any damage that may affect
operator safety or operation of saw. Check for
alignment or binding of moving parts. Check
for broken or damaged parts. Do not use saw
if damage affects safety or operation. Have
damage repaired by authorized service center.
3.
Maintain saw with care:
• Never expose saw to rain.
• Keep chain sharp, clean, and lubricated
for better and safer performance.
• Follow steps outlined in this manual to
sharpen chain.
• Keep handles dry, clean, and free of oil
and grease.
• Keep all screws and nuts tight.
• Inspect power cord often. If damaged,
have repaired by authorized service cen
ter.
• Never carry saw by power cord.
• Never yank power cord to unplug it.
• K
eep power cord from heat, oil, and sharp
edges.
• Inspect extension cords often and re
place if damaged.
4. When servicing, use only identical replace-
ment parts.
5. When not
in use, always store saw:
• in a high or lock
ed place, out of children’s
reach
• in a dry place
• in a carrying case or with scabbard over guide
bar
•
drain oil after each use and before storing saw
to prevent oil leakage.
Save these instructions. It is your guide to safe
and proper operation of this saw.
MAINTENANCE AND STORAGE OF
SAW
• For chain saw, use firm grip. Thumbs and
fingers must wrap around saw handles.
• For pole saw, have one hand gripping the
handle and the other gripping the pole. Use
firm grip. Thumbs and fingers must wrap
around pole and handle.
•
U
se both hands to grip saw while saw is
running. Use firm grip. Thumbs and fingers
must wrap around saw handles.
• Keep all safety items in place
on saw. Make
sure they work properly.
• Chain saw - do not overreach or cut above
shoulder height.
• Pole saw - do not overreach or extend arms
above shoulder height.
• Keep solid footing and b
alance at
all
times.
• Stand slightly to left side
of saw. This keeps
your b
ody from being in direct line with
chain.
• Do
not let guide bar nose touch anything
when chain is moving (see Figure 1).
• Never try cutting through two branches at
same time. Only cut one log at a time.
• Do not bury guide
bar nose or try plunge cut
(boring into wood using guide bar nose).
• Watch for shifting of wood or other forces
that may pinch chain.
• Use extreme caution when r
eenteri
ng a previ
ous
cut.
• Use low-kickback
chain and guide bar sup-
plied with this chain saw. Only replace thes
e
parts with chains and guide bars listed in this
manual.
•
Never use dull or loose chain. Keep chain
sharp with proper tension.
Figure 1 - Kickback Hazard Example: Do Not
Let Nose of Guide Bar Touch Object While
Chain is Moving
90°
Do Not Let
Guide Bar
Touch Here
Follow maintenance instructions in this manual.
Proper cleaning of saw and chain and guide bar
maintenance can reduce chances of kickback.
Inspect and maintain saw after each use. This will
increase the service life of your saw.
Note: Even with proper sharpening, risk of kick-
back can increase with each sharpening.
Direction
6