Filter
Top Products
14
100273
CLEANING AND MAINTENANCE
Continued
Replacing Saw Chain
Replace chain when cutters are too worn to sharpen or when
chain breaks. Only use replacement chain noted in this manual.
Always include new drive sprocket when replacing chain. This
will maintain proper driving of chain.
Note:
For proper chain
and drive sprocket, see Replacement Parts, below.
RECYCLING
In the event it is not practical to repair your chain saw, be sure
to follow local and country codes for recycling plastic and
metallic materials when disposing of the unit.
STORAGE
If storing saw for more than 30 days, follow steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain. Clean guide bar
and chain by soaking in petroleum based solvent or mild
soap and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil. This will prevent
rust.
5. Wipe a thin coating of oil over surface of guide bar.
6. Wipe off outside of saw body. Do this with soft cloth
dampened with a mild soap and water mixture.
7. Store chain saw
• in a high or locked place, out of children’s reach
• in a dry place
• in a carrying case or with scabbard over guide bar
REPLACEMENT PARTS
!
WARNING ICON G 001
WARNING
Use only replacement parts described in this
manual. Use of other parts could damage saw or
injure operator.
Purchase these parts from your local dealer.
Part Number Description
097570-01 Guide bar, 350 mm
091374S Chain, 350 mm
075752 Drive sprocket