Filter
Top Products
12
100273
CLEANING SAW BODY
Keep saw body clean. Use a soft cloth dampened with a mild
soap and water mixture. Wipe saw body to clean.
CARE OF GUIDE BAR
Uneven bar wear causes most guide bar problems. Incorrect
sharpening of chain cutter and depth gauge settings often cause
this. When bar wears unevenly, it widens guide bar groove (see
Figure 18). This causes chain clatter and rivet popping. Saw
will not cut straight. Replace guide bar if this occurs.
Inspect guide bar before sharpening chain. A worn or damaged
guide bar is unsafe. A worn or damaged guide bar will damage
chain. It will also make cutting harder.
CLEANING AND MAINTENANCE
NOTICE
Below are instructions for servicing your chain
saw. Any servicing not mentioned below should
be done by an authorized service person.
!
WARNING ICON G 001
WARNING
Unplug chain saw from power source before
servicing. Severe injury or death could occur
from electrical shock or body contact with
moving chain.
!
WARNING ICON G 001
WARNING
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
Normal Guide Bar
Guide Bar With
Uneven Wear
Figure 18 - Guide Bar Cross Section Showing
Uneven Bar Wear
Guide Bar
Groove
Guide Bar
Normal Guide Bar Maintenance
1. Remove guide bar from chain saw.
2. Remove sawdust from guide bar groove periodically. Use
putty knife or wire.
3. Clean oil slots after each day of use.
4. Remove burrs from sides of guide bar. Use flat file to make
side edges square.
Replace guide bar when
• bar is bent or cracked
• inside groove of bar is badly worn
Note:
When replacing guide bar, see Replacement Parts, page
14 for proper bar.
WARNING
When cleaning saw body,
• do not submerge saw in any liquids
• do not use products that contain ammonia,
chlorine, or abrasives
• do not use chlorinated cleaning solvents,
carbon tetrachloride, kerosene, or gasoline
SHARPENING YOUR SAW CHAIN
Keep chain sharp. Your saw will cut faster and more safely. A
dull chain will cause undue sprocket, guide bar, chain, and
motor wear. If you must force chain into wood and cutting
creates only sawdust with few large chips, chain is dull.
Items Needed to Sharpen Chain
Purchase these items from your local dealer, hardware store, or
chain saw supplies outlet.
• 4 mm round file • Depth gauge tool
• File guide • Vise
• Medium sized flat file
Cleaning Groove
With Putty Knife
Oil Slot
Flat File
Burr
Guide
Bar
Figure 19 - Guide Bar Maintenance
!
WARNING ICON G 001
WARNING
Unplug chain saw from power source before
servicing. Severe injury or death could occur
from electrical shock or body contact with
moving chain.
!
WARNING ICON G 001
WARNING
Cutting edges on chain are sharp. Use protective
gloves when handling chain.