Filter
Top Products
4 |
3 blower/vac assembly
Assembling Blower
Follow the steps below to assemble the
blower. IMPORTANT: e blower will not
run unless the bottom inlet cover is locked
into place.
1. Slide the blower tube onto outlet on
front of blower/vac housing (see Fig-
ure 3-1). Securely connect the draw
latch to the blower tube (see Figure
3-2).
2. Position front of bottom inlet cover
over motor housing hook (see Figure
3-3).
3. Pivot bottom inlet cover to bottom
of blower/vac housing. Slightly press
locking lever on bottom inlet cover
to allow cover to lock into place (see
Figures 3-4 and 3-5).
Figure 3-5: Pressing locking lever
WARNING: To Reduce The
Risk of Personal Injury or Electric
Shock – Disconnect from power
source before assembling or
changing attachments.
Figure 3-1: Sliding blower tube into place
Figure 3-3: Attaching bottom inlet cover to motor housing
hook
Figure 3-4: Pivoting bottom inlet cover to blower/vac
housing
Figure 3-2: Connect draw latch to blower tube
120133
1
2
3
4