Filter
Top Products
26
8. Operation
English
It is very dangerous to run a chainsaw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts
including bar and chain are installed properly.
■ STARTING ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely. (F4)
(1) Chain oil
(2) Fuel
2. Tilt the switch lever upward. (F5)
(3) Switch
3. While holding the throttle lever together with the
throttle interlock, push in the side latch and release the
throttle lever to hold it at the starting position. (F6)
(4) Throttle lever
(5) Throttle interlock
(6) Latch
4. Pull out the choke knob to the closed position. (F7)
(7) Choke knob
When restarting immediately after stopping the engine,
Ieave the choke knob at the open position.
NOTE
WARNING
F4
F5
F6
F7