Filter
Top Products
Profoto D4 –Generators
D4D4
Profoto D4 – Generators
Profoto 28 The Light Shaping Company The Light Shaping Company
29 Profoto
the Power Display [10] from 1-32 by turning the Power Dial [13] for outlet D. At channels
16-32 it’s also possible to change the sub channels (“quads”) from “A”, “b”, “C” to “d”
by pressing down the dial while rotating.
How to activate or deactivate Auxiliary
functions
Release the Auxiliary Functions Button [7] after setting the function(s). The Auxiliary
Functions Display
[8] will now show the chosen function and the generator works with this
settings. If more than one auxiliary function is activated, the display shows intermittently
all functions.
To turn off any of the auxiliary functions, simply hold down the
Auxiliary Functions Button
[7] and push the Flash and Modelling Light Button(s) [12] at the corresponding outlet(s) –
an “Off” in the display indicates that the regarding function is deactivated. If no auxiliary
function is activated, the Auxiliary Functions Display [8] will indicate “- -”.
Memory Function
It is possible to save up to three combined power and auxiliary function settings in the D4’s
memory. This makes it easier to repeat even the most complex set-ups. With the “Profoto
Studio” software you can save an almost unlimited number of set-ups (see page 35-40).
PLEASE NOTE! When deactivating the D4 with the
On/Standby Button [3],
the generator automatically saves the last power (of all outlets) and auxiliary
settings in memory A. The Aposition is used as “safety memory” and can’t be
programmed individually. After reactivating the D4 by pushing the
On/Standby
Button
[3], the generator automatically starts with these settings. To prevent
mistakes, all auxiliary functions (except the radio channel) stored in this memory
are deactivated if the generator was disconnected from the mains. If you want
to use them, it is necessary to activate them again (see page 26).
Additionally it is possible to store three complete setups in memory B, C and D permanently.
How to save:
1. After setting the generator press and hold down the Ws/f-stop Switch and Memory
Button
[11], the Ready Lamp [18] goes off and a double beep signal confirms that
you entered the memory mode.
2. While still holding down the
Ws/f-stop Switch and Memory Button [11], you choose
the memory position by pressing and holding down one Flash and Modelling Light
On/Off Button
[12] at outlet B, C or D.
3. Now you release the Ws/f-stop Switch and Memory Button [11] first, a beep confirms
the setting and you can also release the
Flash and Modelling Light On/Off Button [12] –
the
RReeaaddyy LLaammpp
[18] is lit again.
How to recall:
1. Press and hold down the Ws/f-stop Switch and Memory Button [11]. The Ready
Lamp
[18] goes off and a double beep signal confirms that you have entered the
memory mode.
2. Quickly press the
Flash and Modelling Light On/Off Button [12] of the desired memory
once. It is possible to check the content of the three memories by pushing the different
Flash and Modelling Light On/Off Buttons [12] at outlets B, C and D.
3. Release the
Ws/f-stop Switch and Memory Button [11] a beep signal and the activated
Ready Lamp [18] confirm the setting and the generator uses the functions stored in
the selected memory.