Filter
Top Products
7
Operation:
-----------------------------------------------------------------------------------------------------
CAUTION
THE TOP COVER MUST BE IN PLACE BEFORE THE LAMP IS TURNED ON!
-------------------------------------------------------------------------------------------------------------------
Connections for the XS-432
1. Connect the DC power cable between the XS-432 lamp housing and the
Optiquip power supply.
2. Connect the line cord between the lamp housing fan and the outlet on the rear
of the Optiquip power supply.
3. With the power switch on the Optiquip power supply switched off, plug its
line cord into a 110 volt outlet.
To Turn Lamp On:
1. Turn on the switch on the Optiquip power supply to ignite the Xenon lamp.
This may take several seconds depending on the age and temperature of the
Xenon bulb.
2. The Optiquip power supply is preadjusted for a power of 75 watts to operate
the Xenon lamp by Princeton Instruments. If the power is not 75 watts during
operation, refer to the Optiquip power supply instruction manual.
-----------------------------------------------------------------------------------------------------
WARNING
IF LOUD SNAPPING SOUNDS ARE HEARD FROM THE LAMP HOUSING OR
POWER SUPPLY DIRNG IGNITION, TURN OFF THE POWER SUPPLY
IMMEDIATELY AND CHECK ALL CABLE CONNECTIONS.
FAINT CLICKING SOUNDS DURING IGNITION ARE NORMAL.
-------------------------------------------------------------------------------------------------------------------
To Turn Lamp Off:
1. Turn off power switch on the Optiquip power supply.
Refer to the attached manufacturer’s instruction manual for more details on
operation of the power supply and lamp.