Powermate P-FTT-160MD-[E] Tiller User Manual


 
Questions? Call Toll Free at 1-800-737-2112 Copyright © 2009 MAT Engine Technologies, LLC
8
Assembly Instructions
B
Assembly (Continued)
• Save all instructions
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
INSTALL THE WHEELS (See Figure 2)
1. Slide the wheel hub onto the wheel axle.
2. Add the locking washer and pin to secure wheel.
ATTACH UPPER HANDLE (See Figure 3)
1. Slide the upper handle down over the lower handle and
align the holes.
2. Insert the saddle bolts into the holes as shown and
securely with the handle knobs.
3. Tighten the handle knobs securely.
Figure 2
Saddle Bolts
Saddle Bolts
Handle Knobs
Handle Knobs
Figure 3
INSTALL THE DEPTH REGULATOR (See Figure 4a and 4b)
1. Remove the bolt and knob from the depth regulator lever.
2. Insert the depth regulator into the bottom of the depth
regulator bracket.
3. Insert the detent pin thru the bracket and lever.
4. Insert the cotter key to secure the pin.
Figure 4a
Figure 4b
The tiller comes fully assembled except for a few parts. The following instructions will help you complete the tiller assembly.