Filter
Top Products
CUSTOMER RESPONSIBILITIES
FILL IN DATES
ASYOUCOMP.ETE
REGULAR SERVICE J__/"S E RVIC E
DATES
/_f f ir
Check Operator Presence and
T Interlock Systems I1 #
R Check for Loose Fasteners If V'5 I_
A Sharpen/Replace Mower Blades I_
C Lubrication Chart If
0 Check Battery Level
R Clean Battery and Terminals V'
Check Transaxle Cooling If
Check V-Belts I_
Check Engine Oil Level V'
Change Engine Oil (with oil filter) 1111_2 If
E Change Engine Oil (without oil filter) _1,2 !
N CleanAirFilter _;
G Clean Air Screen
NI Inspect Muffler/Spark Arrester If
E Replace Oil Filter (If equipped) _.2
Clean Engine Cooling Fins _ 2
Replace Spark Plug
Replace Air Filter Paper Cartridge
Replace Fuel Filter
1 - Change more often when operating under a heavy _oador
in high ambient temperatures,
2 - Service more often when operating in dirty or dusty conditions.
q/
3 - Replace blades more often when mowing in Sandy soil
4 - Not required if equipped with maintenance-free battery.
5 - Tighten front axle pivot bolt to 35 ft.-ibs, maximum.
Do not overtighten.
GENERAL RECOMMENDATIONS
LUBRICATION CHART
The warranty on this tractor does notcover items that have
been subjected to operator abuse or negligence. To receive
full value from the warranty, operator must maintain tractor
as instructed in this manual.
Some adjustments will need to be made periodically to
properly maintain your tractor.
All adjustments in the Service and Adjustments section of
this manual should be checked at least once each season.
• Once a year you should replace the spark plug, clean or
replace air filter, and check blades and belts for wear. A
new spark plug and clean air filter assure proper air-fuel
mixture and help your engine run better and last longer.
BEFORE EACH USE
• Check engine oil level.
• Check brake operation.
• Check tire pressure.
• Check operator presence and
interlock systems for proper operation,
• Check for loose fasteners.
ZERK ZERK
(_FRONT "_)FRONT WHEEL
BEARING _ BEARING ZERK
15
I
I
I
I
i I
(_SAE 30 OR lOW30 MOTOR OIL
(_GENERAL PURPOSE GREASE
(_GEARSHIFT
a
- • PIVOTS
I
_)REFER TO CUSTOMER RESPONSIBILITIES "ENGINE"
SECTION
IMPORTANT: DO NOT OIL OR GREASE THE PIVOT
POINTS WHICH HAVE SPECIAL NYLON BEARINGS.
VISCOUS LUBRICANTS WILL ATTRACT DUST AND DIRT
THAT WILL SHORTEN THE LIFE OF THE SELF-
LUBRICATING BEARINGS. IF YOU FEEL THEY MUST BE
LUBRICATED, USE ONLY A DRY, POWDERED
GRAPHITE TYPE LUBRICANT SPARINGLY.