Filter
Top Products
SERVICE AND ADJUSTMENTS
CONTROL
,NEUTRAL
LOCK GATE
ADJUSTMENT
\ BOLT
FIG. 25
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positionedstraightforward, remove steer-
ingwheel and reassemble per instructionsinthe Assembly
section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The frontwheel toe-inand camberare notadjustableonyour
tractor. Ifdamage hasocourredtoaffectthe frontwheel toe-
in or camber, contact your nearest authorized service
center/department.
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 26)
• Block up axle securely.
• Remove axle cover, rataining ringand washers toallow
wheel removal(rearwheel containsa square key- Do not
lose).
• Repairtire and reassemble.
• Onrearwheelsonly: aligngroovesinrearwheelhuband
axle. Insert square key.
• Replace washers and snap retaining dng securely in
axle groove.
• Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.
Ifyour battery istoo weak to start the engine, itshould be
recharged. (See "BATFERY" inthe CUSTOMER RESPON-
SIBILITIES section of this manual).
If=jumper cables" are used for emergency starting, follow
thisprocedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A
12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
• Connect one end of the RED cabletothe POSITIVE (+)
terminal of each battery(A-B), taking care not to short
against tractor chassis.
• Connect one end ofthe BLACK cable tothe NEGATIVE
(-) terminal (C) of fully charged battery.
• Connect the other end of the BLACK cable (D) to gcod
chassis ground, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
• BLACK cable first from chassis and then from the fully
charged battery.
• RED cable last from both batteries.
WEAK OR DEAD FULLY CHARGED
BATTERY BATTERY
RG. 27
REPLACING BATrERY (See Figs. 28 and 29)
WASHERS
RETAINING RING
AXLE COVER
SQUAREKEY(REAR _......_' •
WHEEL ONLY) _- •
FIG. 26
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 27)
explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries. Always wear eye protection when
around batteries.
22
Lift seat pan to raised position.
Disconnect BLACK battery cable first then RED battery
cable and carefully remove battery from tractor.
Installnew batterywithterminalsinsame position as old
battery.
Firstconnect RED battery cable to positive (+) terminal
with hexboltand keps nut as shown. Tighten securely.
Slide terminal cover over terminal.
Connect BLACKgrounding cable tonegative(-) terminal
with remaining hexboltand kepsnut.Tighten securely.