Filter
Top Products
MAINTENANCE
• Unlock drain valve by pushing inward and turning
counterclockwise,
• To open, pull out on the drain valve,
• After oil has drained completely, close and lock the
drain valve by pushing inward and turning clockwise
until the pin is in the locked position as shown,
• Remove the drain tube and replace the cap onto to the
bottom fitting of the drain valve.
• Refill engine with oil through oil fill dipstick tube, Pour
slowly. Do not overfill. For approximate capacity see
"PRODUCT SPECIFICATIONS" section of this man-
ual.
• Use gauge on oil fill cap/dipstick for checking level,
Be sure dipstick cap is tightened securely for accurate
reading. Keep oil at"FULU' line on dipstick.Tighten cap
onto the tube securely when finished.
CLEAN AIR SCREEN
Air screen must be kept free of dirt and chaff to prevent
engine damage from overheating, Clean with a wire brush
or compressed air to remove dirt and stubborn dried gum
fibers, See engine manual,
AIR FILTER
Your engine will not run properly using a dirty air filter. Clean
the foam pre-cleaner after every 25 hours of operation or
every season, Service paper cartridge every 50 hours
of operation or every season, whichever occurs first. See
engine manual,
CLEAN AIR INTAKE/COOLING AREAS
To insure proper cooling, make sure the grass screen,
cooling fins, and other external surfaces of the engine are
kept clean at all times,
Every 100 hours of operation (more often under extremely
dusty, dirty conditions), remove the blower housing and
other cooling shrouds. Clean the cooling fins and external
surfaces as necessary, Make sure the cooling shrouds are
reinstalled,
NOTE: Operating the engine with a blocked grass screen,
dirty orplugged cooling fins, and/or cooling shrouds removed
will cause engine damage due to overheating,
MUFFLER
Inspect and replace corroded muffler and spark arrester
(if equipped) as it could create a fire hazard and/or dam-
age.
SPARK PLUGS
Replace spark plugs at the beginning of each mowing
season or after every 100 hours of operation, whichever
occurs first, Spark plug type and gap setting are shown in
"PRODUCT SPECIFICATIONS" section of this manual,
IN-LINE FUEL FILTER (See Fig. 23)
The fuel filter should be replaced once each season, If fuel
filter becomes clogged, obstructing fuel flow to carburetor,
replacement is required,
• With engine cool, remove filter and plug fuel line sec-
tions,
• Place new fuel filter in position in fuel line with arrow
pointing towards carburetor,
• Be sure there are no fuel line leaks and clamps are
properly positioned,
• Immediately wipe up any spilled gasoline.
CLAMP
FUEL _ CLAMP
FILTER
FIG. 23
CLEANING
• Clean engine, battery, seat, finish, etc. of all foreign
matter,
• Keep finished surfaces and wheels free of all gasoline,
oil, etc.
• Protect painted surfaces with automotive type wax.
We do not recommend using a garden hose or pressure
washer to clean your tractor unless the engine and trans-
mission are covered to keep water out, Water in engine or
transmission will shorten the useful lifeof your tractor, Use
compressed air or a leaf blower to remove grass, leaves
and trash from tractor and mower.
21