Filter
Top Products
MAINTENANCE
FLAT i
WASHER
BLADE BOLT
LEFT HAND
THREADED%
LOCK
WASHER
ASSEMBLY
6 STAR PATTERN
6 STAR CENTER HOLE
TRAILING
" _ EDGE
FIG. 21
BATTERY
Yourtractor has a battery charging system which is sufficient
for normal use. However, periodic charging of the battery
with an automotive charger will extend its life,
• Keep battery and terminals clean,
• Keep battery bolts tight,
• Keep small vent holes open,
• Recharge at 6-10 amperes for 1 hour,
NOTE: The original equipment battery on your tractor is
maintenance free, Do not attempt to open or remove caps
or covers. Adding or checking level of electrolyte is not
necessary.
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and terminals can cause
the battery to "leak" power,
• Remove battery cover,
• Disconnect BLACK battery cable first then RED bat-
tery cable and remove battery from tractor,
• Rinse the battery with plain water and dry.
• Clean terminals and battery cable ends with wire brush
until bright,
• Coat terminals with grease or petroleum jelly.
• Reinstall battery (See "CONNECT BATTERY" in the
Assembly section of this manual).
V-BELTS
Check V-belts for deterioration and wear after 100 hours
of operation and replace if necessary. The belts are not
adjustable. Replace belts if they begin to slip from wear,
TRANSAXLE COOLING
The transmission fan and cooling fins should be kept clean
to assure proper cooling.
Do not attempt to clean fan or transmission while engine
is running or while the transmission is hot, Toprevent pos-
sible damage to seals, do not use high pressure water or
steam to clean transaxle,
• Inspect cooling fan to be sure fan blades are intact and
clean,
• Inspect cooling fins for dirt, grass clippings and other
materials.To prevent damage to seals, do not use com-
pressed air or high pressure sprayer to clean cooling
fins,
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and fluid mainte-
nance is not required for the life of the transaxle, Should
the transaxle ever leak or require servicing, contact your
nearest authorized service center/department,
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service
classification SG-SL. Select the oil's SAE viscosity grade
according to your expected operating temperature.
SAE VISCOSITY GRADES
| I,
<
F -20 0 30 32 40 60 80 100
i i i i i
C -30 -2'0 -10 1'0 20 30 40
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
oil visc chart1 e
NOTE: Although multi-viscosity oils (5W30, 10W30 etc.)
improve starting incold weather, they will result in increased
oil consumption when used above 32°E Checkyour engine
oil level more frequently to avoid possible engine damage
from running low on oil.
Change the oil after every 25 hours of operation or at least
once a year if the tractor is not used for 25 hours in one
year.
Check the crankcase oil level before starting the engine
and after each eight (8) hours of operation. Tighten oil fill
cap/dipstick securely each time you check the oil level.
TO CHANGE ENGINE OIL (See Fig, 22)
Determine temperature range expected before oil change,
All oil must meet API service classification SG-SL,
• Be sure tractor is on level surface,
• Oil will drain more freely when warm.
• Catch oil in a suitable container,
• Remove oil fill cap/dipstick. Be careful not to allow dirt
to enter the engine when changing oil.
• Remove yellow cap from end of drain valve and install
the drain tube onto the fitting.
OIL DRAIN VALVE
AND
LOCKED
POSITION
CAP
TUBE
20 FIG. 22