Filter
Top Products
CouplerPrimaryHole
GuideRecess
Locking/
UpperReleaseLower
Shaft Attachment
Button
='_WARNING: Make sure the locking/
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. AIt attachments are designed
to be used in the primary hole unless otherwise
stated in the applicable attachment instruction
manual. Using the wrong hole could lead to seri-
ous injury or damage to the unit.
Secondary Hole
Locking/Release
Button in Primary Hole
For optional attachments, see the AS-
SEMBLY section of the applicable attach-
ment instruction manual.
ATTACHING SHIELD
,_& WARNING: Theshieldmustbeprop-
erlyinstalled. The shieid provides partial protec-
tion from the risk of thrown objects to the opera-
tor and others and is equipped with a _inelimiter
blade which cuts excess line to the proper
length. The line limiter blade (on underside of
shield) is sharp and can cut you, For proper
orientation of shield, see KNOW YOUR TRIM-
MER illustration in OPERATION section.
1. Remove wing nut from shield,
2. Insert bracket into slot as shown,
3. Pivot shield until bolt passes through hole
in bracket.
4. Securely tighten wing nut onto bolt.
Slot
Shield /
__1_ I Bra,cket
/
Line Limiter Blade _ _ NWiu_g
ADJUSTING THE ASSIST HANDLE
,_ WARNING: When adjusting the assist
handle, be sure itremains above the safety label
and below the mark or arrow on the shaft,
1. Loosen wing nut on handle.
2. Rotate the handle on the shaft to an up-
right position; retighten wing nut,