Filter
Top Products
• Donotattempttoremovecutmaterialnor
hotdmaterialtobecutwhentheengineis
runningorwhencuttingbladeismoving.
• Alwayskeepthewheelanddepthadjusting
skidincontactwiththeground.
• Alwayspushtheunitslowlyoverthe
ground.Stayalertforunevensidewalks,
holesintheterrain,largeroots,etc.
• Alwaysusethehandlebarwhenusingedg-
erattachment.
BLOWER/VACUUM SAFETY
_WARNING: Inspect area before
starting unit. Remove all debris and hard ob-
jects such as rooks, glass, wire, etc. that can
ricochet, be thrown, or otherwise cause injury
or damage during operation.
• Do not set unit on any surface except a
clean, hard area while engine is running.
Debris such as gravel, sand, dust, grass,
etc., could be picked up by the air intake
and thrown out through discharge opening,
damaging unit, property, or causing serious
injury to bystanders or operator.
• Never place objects inside the blower
tubes, vacuum tubes or Mower outlet. Al-
ways direct the blowh_g debris away from
people, animals, glass, and solid objects
such as trees, automobiles, wails, etc. The
force of air can cause rocks, dirt, or sticks to
be thrown or to ricochet which can hurt
people or animals, break glass, or cause
other damage.
• Never run unit without the proper equip-
ment attached. When using your unit as a
blower, always install blower tubes.
• Check air intake opening, blower tubes or
vacuum tubes frequently, always with en-
gine stopped and spark plug disconnected.
Keep vents and discharge tubes free of de-
bris which can accumulate and restrict
proper air flow.
• Never place any object inair intake opening
as this could restrict proper air flow and
cause damage to the unit.
• Never use for spreading chemicals, fertiliz-
ers, or other substances which may contain
toxic materials.
• To avoid spreading fire, do not use near leaf
or brush fires, fireplaces, barbecue pits,
ashtrays, etc.
BRUSHCUTTER SAFETY
A
DANGER: Blade can thrust violently
away from material it does not cut. Blade
thrust can cause amputation of arms or legs.
_ WARNING: Do not use trimmer head
as a fastening device for the blade.
m_WARNING: The blade continues to
spin after the throttle is released or engine is
turned off. The coasting blade can throw ob-
jects or seriously cut you if accidentally
touched. Stop the blade by contacting the
right hand side of the coasting blade with ma-
terial already cut.
Stop coasting
Made by contact
with cut material.
,. ®
_'_
4[1WARNING: Inspect the area to be
cut before each use. Remove objects (rocks,
broken glass, nails, wire, etc.) which can be
thrown or become entangied in the blade or
trimmer line.
• Throw away and replace blades that are
bent, warped, cracked, broken or damaged
in any other way.
• install required shield properly before using
the unit. Use the metal shield for all metal
blade use.
WARNING: Only use brushcutterat-
tachments that provide a metal shield with
proboscis nose.
PrlOoOOeScis
• Use only specified blade and make sure it is
properly installed and securely fastened.
• Cut from your left to your right. Cutting on
the right side of the shield will throw debris
away from the operator.
• Always use the handlebar and a properly
adjusted shoulder strap with blade (see AS-
SEMBLY instructions in brushcutter attach-
ment instruction manual).
CULTIVATOR SAFETY
,_ WARNING: Rotatingtines cancause
serious injury. Keepaway from rotatingtines.
Stop the engine and disconnect the spark
pIug before unclogging tines or making re-
pairs.
4