Filter
Top Products
9
Throttle Trigger
ON/OFF
Switch
HOW TO START YOUR UNIT
WARNING:
The trimmer head will
turn while s tarting the engine. Avoid any con-
tact with the muffler. A hot muffler can cause
serious burns.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
Starting Position
Muffler
Choke
Lever
Starter Handle
Primer Bulb
1. Set unit on a flat surface.
2. MoveON/OFF switch to the ONposition.
3. Slowly press the primer bulb 6 times.
4. Move choke lever to FULL CHOKE by
aligning lever with position shown on de-
cal (see illustration below).
Choke
position
decal
5. Squeeze the throttle trigger fully and hold
through
all remaining steps.
6. Pull starter rope handle sharply until en-
gine sounds as ifit istrying tostart, but do
not pull rope more than 6 times.
7. As soon asengine sounds as if it istrying
to start, move choke lever to HALF
CHOKE by aligning lever with position
shown on decal (see illustration below).
Choke
position
decal
8. Pull st ar ter rope sharply until engine runs,
but no more than 6 pulls. If the engine
doesn’t start after 6 pulls (at the HALF
CH OKE position), move the choke lever to
the FULL C H OKE position and press the
primer bulb 6 times. Squeeze and hold the
throttle trigger and pull the st arter rope 2
more times. Mov e the ch o k e le v e r to the
HALF CHOKE position and pull the starter
ropeuntil the engineruns,but nomorethan
6 pulls. If the engine doesn’t start, repeat
procedure 2 additional times.
NOTE:
If engine still doesn’t s tart, it is
probablyflooded. Proceedto STARTINGA
FLOODED ENGINE.
9. O ncetheenginestarts,allowit torun10se-
conds, then m ove the choke l ever to OFF
CH OKE by aligning lever with position
shown on dec a l (s e e illustration below). Al-
low the unit to run for 3 0 more seconds at
OFF CH O KE before r eleasing the throttle
trigger.
NOTE:
If engine dies w ith the
choke lever in the O FF CHO KE position,
movethechoke leverto the H ALF C H O KE
position and pull the rope until engine runs,
but no more than 6 pul ls.
Choke
position
decal
STARTING A WARM ENGINE
1. MoveON/OFF switch to the ONposition.
2. Move the choke lever to the HALF
CHOKE position.
3. Squeeze and hold the throttle trigger.
Keep throttle trigger fully squeezed until
the engine runs smoothly.
4. Pull st ar ter rope sharply until engine runs,
but no more than 5 pul ls.
5. Allow engine to run 15 seconds, then
movethe choke levertothe O FFCHOKE
position.
NOTE:
If engine has not started, pull starter
rope 5m orepulls. If engine still does notrun, it
is probably flooded.
STARTING A FLOODED ENGINE
Flooded engines can be started by placing
the choke lever in the OFF CHOK E position;
then, pull the rope to clear the engine of ex-
cessfuel. This couldrequire pulling thestarter
handle many times depending on how badly
the unit is flooded.