Filter
Top Products
18
Idle Speed--T
Allow engin e to idle. If the chain moves, idle is
toofast. Ifthe e ngin estalls, id leis tooslo w . Ad-
just speed until engine runs without chain
movement (idle t oo fast) or stalling (idle too
slow). The idle speed screw is located in the
area above the primer bulb and is labeled T.
S Turn idle screw (T) clockwise to increase
engine speed.
S Turn idle screw (T) counterclockwise to
decrease engine speed.
If you require further assistance or are unsure
about performing this procedure, contact your
authorized service dealer or call our customer
assistance help line at 1--800--554--6723.
COOLING SYSTEM
To keep the working temperature as low as
possible the machine is equipped with a
cooling system.Thecoolingsystemconsists
of:
S Air intake on the starter
S Air guide plate
S Fins on the flywheel
S Cooling fins on the cylinder
S Cylinder cover (directs cold air over the
cylinder)
Clean the cooling system with a b rush after
each use, more often in demanding condi-
tions. A dirty or blocked cooling system re-
sults in the machine overheating which
causes damage to the piston and cylinder.
STORAGE
WARNING: Perform t he following
steps after each use:
S Allow the engine to cool, and secure the
unit before storing or transporting.
S Store chain saw and fuel in a well venti-
lated area where fuelvapors cannot reach
sparks oropen flamesfromwaterheaters,
electric motors or switches, furnaces, etc.
S Store chain saw with all guards in place
and position chain saw so that any sharp
object cannot accidentally cause injury.
S Store chain saw well out of the reach of
children.
SEASONAL STORAGE
Prepare your unit for storage at the end of the
season or if it will not be used for 30 days or
more.
If your chain saw is to be stored for a period
of time:
S Clean saw thoroughly before storage.
S Store in a clean dry area.
S Lightly oil external metal surfaces and
guide bar.
S Oil thechain and wrap it in heavy paper or
cloth.
FUEL SYSTEM
Under FUELING ENGINE i n the OPERA-
TION section of this manual, see message
labeled IMPORTANT regarding the use of
gasohol in your chain saw.
Fuel stabilizer is anacceptable alternativein
minimizing the formation of fuel gum depos-
its duringstorage. Addstabilizerto the gaso-
line in the fuel tank or fuel storage container .
Follow the mix instructions found onstabiliz-
er containers. Run engine at least 5 minutes
after adding stabilizer .
Poulan/WEED EA TER 40:1, 2-cycle engine
oil (air cooled) is blended with fuel stabilizer .
If you do not use this oil, you can add a fuel
stabilizer to your fuel tank.
HELPFUL TIP
During storageof your gas/
oilmixture, theoil will sepa-
rate from the gas.
We recommend that you
shake the gas can weekly
toinsure p roper blendingof
the gas and oil.
ENGINE
S Remove spark plug and pour 1 teaspoon of
40:1, 2-cycle engine oil (air cooled) through
the spark plug opening. Slowly pull the start-
er rope 8 to 1 0 times to distribute oil.
S Replace spark plug with new one of rec-
ommended type and heat range.
S Clean air filter.
S Check entire unit for loose screws, nuts,
and bolts. Replace any damaged, broken,
or worn parts.
S At the beginning of the next season, use
only fresh fuel having the proper gasoline
to oil ratio.
OTHER
S Do not store gasoline from one season to
another.
S Replace your gasoline can if it starts to rust.