Filter
Top Products
4
operateina localewheresuch regulationsex-
ist, you are legallyresponsible formaintaining
the oper atingconditionof theseparts. Fa ilure
to do so is a violation of the law. For normal
homeowner use,the muf flerand s parkarrest-
ing screen will not require any service.
After 50 hours of use, we recommend that
your muffler be serviced or replaced by y our
authorized service dealer .
WARNING: The muffleron this prod-
uct contains chemicals known to the State of
California to cause cancer.
ASSEMBLY
CARTON CONTENTS
Check carton contents against the following
list:
S Brushcutter
S Handlebar screws (2)
S Blade shield screws (4)
S Cupped washer
S Large nut for installing blade
S Hex wrench
S Bracket cover
S Metal shield
S Plastic s hield
S Shoulder strap with warning
S 4--point weed blade
S T rimmer head (assembled on unit)
S Handlebar
S Wing nut (screwed onto shield)
S Container of oil
WARNING: Always s topunitand dis -
connect spark plugbefore perf ormingany as-
sembly procedures.
WARNING: I f received assembled,
repeat allsteps to ens ure yourunit is properly
assembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
NOTE: If y ou need assistance or find parts
missing or damaged, call 1-800-554-6723.
It is normal for the fuel filter to rattle in the
empty fuel tank.
Finding fuel oroil residue on muffler is nor mal
due to carburetor adjustments and testing
done by the manufacturer.
TOOLS REQUIRED
S Hex wrench (provided)
S Adjustable wrench or large pliers
S Phillips screwdriver
ATTACHING THE HANDLEBAR
WARNING: During blade usage, the
barrier portion of the handlebar must be
installed as shown to provide a barrier be-
tween operator and the spinning blade.
1. Locate t he decal on the handlebar. This
decal includes an arrow. Position the
handlebar with the mounting bracket at
the end of the arrow.
2. Position the bracket cover over the han-
dlebar. Again make sure the handlebaris
at the end of the arrow.
3. Insert screws and hand tighten only. Be
sure the handlebar is installed correctly;
then, tighten each screw securely with
the hex wrench.
Screw
Mounting
Bracket
Handlebar
Bracket Cover
ASSEMBLY OF SHOULDER STRAP
WARNING: Proper shoulder strap
and handlebar adjustments m ust be made with
the engine completely stopped before using
unit.
1. Insert your right arm and head through
the shoulder strap and allow it to rest on
your left shoulder. Make sure the danger
sign ison your back andthehook istothe
right side of your waist.
NOTE: A one-half twist is built in the shoul-
der strap to allow the s trap to r est flat on the
shoulder.
2. Adjust the strap, allowing the hook t o be
about 6 inches below the waist.
3. Fasten the strap hook to the clamp located
between the trigger handle and the handle-
bar clamp base and lift the tool to the oper-
ating position.
4. Try on shoulder strap and adjust for fit
and b alance before starting the engineor
beginning a cutting operation.
NOTE: It may be necessary to relocate the
shoulder strap clamp on the s haft for proper
balancing of unit.
TO RELOCATE SHOULDER ST RAP
CLAMP:
1. Loosen and remove both clamp screws.
2. Place the upper shoulder strap clamp
over the tube.
3. Position th e lower shoulder strap clamp
under the tu be and align the upper and
lower clamp screw holes.
Upper Shoulder
Strap Clamp
Screws
Lower Shoulder
Strap Clamp