Filter
Top Products
-- 8 --
UNDERSIDE OF BLADE
Bolt
1/2 turn
4. While holding each bolt in place with a
wrench, retighten the nuts.
TOP SIDE
OF BLADE
NOTE: After adjustment, the washers be-
tween the bolt head and the blade should be
able to be turned by hand, but not loose
enough to mo ve when the unit is tilted from
side to side.
CAUTION: I f the clearance between the
cutting blades is set too wide, the blades will
notcutcorrectly .Ifthebladesareadjustedtoo
tight, overheating may occur.
REPLACE SPARK PLUG
Replace spark plug each year to ensure the
engine starts ea sier and runs better. Set
spark plug gap at 0.025 inch (0.6 mm). Igni-
tion timing is fixed, nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and dis-
card .
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 3/4 inch
(19 mm ) socket wrench.
4. Reinstall the spark plug boot.
REPLACE FUEL FILTER
Toreplacefuelfilter,drainunitby runningitdry
of fuel, then remove fuel cap/retainer assem-
bly from tank. Pull filter fromtank andremove
itfromthefuelline.Installnewfuelfilter onfuel
line; reinstall parts.
Fuel Line
Fuel
Filter
STORAGE
WARNING: Perform the following
steps after each use:
S Allow engine to cool, and secure the unit
before storing or transporting.
S Store unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, e tc.
S Store unit with the blade cover installed.
Position unit so that any sharp object can-
not a ccidentally cause injury .
S Store unit and fuel well out of the reach of
children.
SEASONAL STORAGE
Prepare unitfor storage atend of season or if
it will not be used for 30 days or more.
If your unit is to be stored for a period of time:
S Clean the entire unit.
S Store in a clean dry area.
S Clean all parts and check for damage.
Have damaged parts repaired or replaced
by an authorized service dealer.
S Keep all nuts, bolts, and screws tight.
S Lightly oil external metal surfaces, includ-
ing the blade.
S Install the blade cover .
To oil the blade, do the following:
S Stop theengine and allow bladeto come to
a complete stop.
S Ensure ON/OFF switch is in the OFF posi-
tion.
S Disconnect the spark plug wire.
S Apply a light machine oil along the edge of
the top strap as shown.
Top Strap
OIL
FUEL SYSTEM
Under FUELING ENGINE in the OPERA-
TIONsectionof thismanual,seemessagela-
beled IMPORTANT regarding the use of ga-
sohol in your engine. Fue l st abilizer is an ac-
ceptable alternative in minimizing the formation
of fuel gum deposits during storage. Add stabi-
lizer to gasoline in fuel tank or fuel storage con-
tainer. Follow the mix instructions found on sta-
bilizer container. Run engine a t least 5 mi nutes
after adding stabilizer.
HELPFUL TIP
During storage ofyour gas/
oilmixture, theoil willsepa-
rate from the gas.
We recommend that you
shake the gas can weekly
toinsureproper blendingof
the gas and oil.