Filter
Top Products
7
Coupler Primary Hole
Upper
Shaft
Locking/
Release
Button
Lower
Attachment
Guide Recess
WARNING: Make sure the lo cking/
release button is locked in th e primary hole
and the knob is securely tightened before op-
erating the unit. All at ta c hments a re des igned
to be used in the p rimary hole unless otherwise
stated in the applicable a ttachment instruction
manual. Using thewrong hole could l ead to seri-
ous injury or damage to the unit.
Locking/Release
Button in Primary Hole
Secondary Hole
For optional attachments, see t he ASSEMBLY
section of the applicable attachment instruction
manual.
ATTACHING THE SHIELD
WARNING: The shield must be prop-
erly install ed. Th e shield pro vides partial protec-
tion from the risk of thrown objects to the opera-
tor and others and is equipped with a line limiter
blade which cuts excess line to the proper
length. The line limiter blade (on un derside of
shield) i s sharp a nd can cut you.
For proper orientation of shield, see KNOW
YOUR TRIMMER i l lustration i n OPERATION
secti on.
1. Remove wing nut from shield.
2. Insert bracket i nto slot as shown.
3. Pivot shield until boltpasses through hole in
bracket.
4. Securely tighten wing nut onto bolt.
Wing Nut
Bracket
Slot
Shield
Gearbox
ADJUSTING THE HANDLE
WARNING: When adjusting the han-
dle, be sure it remains above the safety label
and below the mark or arrow on the shaft.
1. Loosen wing nut on handle.
2. Rotate the handle on the shaft to an up-
right position; retighten wing nut.
OPERATION
KNOW YOUR UNIT
READ THIS INSTRUCTION MANUAL AND SAFETYRULES BEFORE OPERATING YOURUNIT.
Compare t he illustrations with your unit to familiarize yourself with the location of the various controls
and adj ustments. Save this manual for f uture reference.
Line Limiter
Blade
Primer Bulb
Assist Handle
Throttle Trigger
Start
Lever
Spark
Plug
Shield
Trimmer
Head
Shaft
Muffler
ON/OFF Switch
Coupler
Starter handle