Filter
Top Products
-- 8 --
S In dusty conditions, slightly dampen sur-
faces oruse amister attachmentwhenwa-
ter is available.
S Conserve water by using power blowers
instead of hoses for many lawn and garden
applications, including areas such as gutters,
screens, patios, g rills, p orches, and gardens.
S Watchoutforchildren,pets,openwindows,
or freshly washed cars. Blow debris away
safely.
S Usethe fullblower nozzleextension sothe
air stream can work close to the ground.
S After using blowers and other equipment,
CLEAN UP! Dispose of debris in trash re-
ceptacles.
BEFORE STARTING ENGINE
WARNING: Be sure to read the fuel
information in thesafety rules before you be-
gin.If youdo notunderstand thesafety rules,
do not attempt to fuel your unit. Call
1-800-554-6723.
FUELING ENGINE
WARNING: Remove fuel cap slowly
when refueling.
HELPFUL TIP
Toobtainthecorrectoilmix
ratio, pour 3.2 ounces of
2--cycle synthetic oil into
one gallon of fresh gas.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good quality
synthetic 2-cycle air-cooled engine oil
designedtobemixedataratioof40:1.Poulan
PRO brand synthetic oil is recommended.
Mix gasoline and oilat a ratio of 40:1. A 40:1
ratiois obtained bymixing 3.2ounces (9 5ml )
of oil wi th 1 g all on (4 li te rs) of unleaded
gasoline. DO NOT U SE automotive oil or
boatoil.Theseoils willcauseenginedamage.
When mixing fuel, follow instructions printed
on container. Once oil is added to gasoline,
shake container momentarily to assure that
thefuelisthoroughly mixed.Always readand
follow the safety rules relating to fuel before
fueling your unit.
IMPORTANT
Experience indicates that alcohol blended
fuels (called gasohol or using ethanol or
methanol)canattractmoisturewhichleadsto
separation and formation of acids during
storage. Acidic gas can damage the fuel
systemofanenginewhileinstorage.Toavoid
engine problems, empty the fuel system
beforestoragefor30days orlonger.Drainthe
gastank,starttheengineandletitrununtilthe
fuellines andcarburetorareempty.Usefresh
fuel next season. Never use engine or
carburetorcleanerproducts inthefueltank or
permanent damage may occur.
NOTE: Unit must be placed on its side when
adding fuel (see illustration below).
TO STOP THE ENGINE
D To stop the engine, move the throttle lever
to the STOP position.
BEFORE STARTING THE ENGINE
WARNING: You MUST make sure
the tubes are secure before using the unit.
D Fuelengine. M oveat least 10feet(3meters)
away from the fueling site.
D Hold the unit in the starting position as
shown.Make suretheblowerendisdirected
away from people, animals, glass, a nd solid
objects.
Blower
Vacuum
ST
A
RTING POSITION
WARNING: When starting engine,
holdtheunit asillustrated.Donotsetunit onany
surfaceexcept aclean, hard area whenstarting
engine or while engine is running. Debris such
as gravel, sand, dust, grass, etc. could be
picked up by the air intake and thrown out
through the discharge opening, damaging the
unit or property , or causing serious injury t oby-
standers or the operator.
HELPFUL TIP
If your engine still does not
start a fter following these
instructions, please call
1--800--554--6723.