Filter
Top Products
-- 5 --
OPERATING THE COUPLER
Your powerhead is equipped with a coupler
which enables optional attachments to be
installed. The optional attachments are:
MODEL:
Edger PPB1000E.....................
Cultivator PPB2000T..................
Brushcutter PPB4000C................
W ARNING:
Always di sconnect pow-
erheadspark plug (or disconnect powerhead
frompowersource)beforeremovingor instal-
ling attachments.
REMOVING ATTACHMENT
CAUTION:
When removingor installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Knob
LOOSEN
TIGHTEN
Upper Shaft
Lower
Attachment
2. Press a nd hold the locking/release button.
Locking/Release
Button
Coupler
Upper Shaft
Lower Attachment
3. While securely holding the upper shaft,
pull the attachment straight out of the
coupler.
INSTALLING ATTACHMENT
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Position locking/release buttonof attach-
ment into guide recess of upper shaft
coupler.
Coupler
Primary Hole
Upper
Shaft
Locking/
Release
Button
Attachment
Guide Recess
3. Pushthe attachmentintothe c oupleruntil
the locking/release button snaps into the
primary hole.
4. Beforeusing t heunit,tightenthe knobse-
curely by turning clockwise.
INSTALLING ATTACHMENT
HANGER
An attachmenthanger is providedfor storage
whenattachmentis notin use.To install hang-
er on attachment:
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release but-
ton.
3. Push hanger onto the attachment until
the locking/release button snaps into the
hole.
OPERATING POSITION
Eye Protection
ALWAYS WEAR:
W ARNING:
Inspect the area before
using the unit. Remove all debris and hard
objects such as rocks, glass, wire, etc., that
can ricochet, be thrown, or otherwise cause
injury or damage during operation.
Use your blower attachment for:
S
Sweeping debris o r grass clippings from
driveways, sidewalks, p atios, et c.
S
Blowing grass clippings, straw , or leaves into
piles, o r rem oving deb ris from corn er s,
around joints, o r between bricks.
Control air flow by directing the blower dis-
charge o pening down or to on e side. Always
work a way f rom solid objects such as walks,
large s tones, vehicles, and fe nces.
Clean corners by starting incorners andmoving
outward. This will help prevent an accumulation
of debris which could fly into your face.
Be careful when working near plants. The force
of the air could damage tender pl ants.